How To Install Liners on MIG Guns Equipped with Wire Brake
Step 1:
- Remove the consumables from the neck.
- At the rear of the neck, insert the wire brake jump liner.
- Push the jump liner forward until it mates with the back end of the neck. At the front, cut to a 1/2″ (12 to 13 mm) stick-out.
![How To Install QUICK LOAD Liners on ,600 amp TOUGH GUN Robotic Water-Cooled MIG Guns Equipped with Wire Brake, step 1](https://beta.tregaskiss.com/wp-content/uploads/2020/07/quick_load_liner_rwc_1-1024x194.png)
Step 2:
- Insert the liner through the rear of the power pin until it stops.
- Measure from the end of the power pin to the liner retainer and record the measurement “X”.
- Remove the liner from the gun.
![How to Install Liners on MIG Guns equipped with wire brake, step 3](https://beta.tregaskiss.com/wp-content/uploads/2013/01/step-3-quick_load_liner_rwc.png)
Step 3:
- At the front of the liner, use the recorded measurement “X” and cut the liner to size.
- The liner should now be ready for installation.
- Insert the liner through the rear of the power pin and thread the retainer into the power pin, or add the liner cap (depending on the type of power pin).
![How To Install QUICK LOAD Liners on 600 amp TOUGH GUN Robotic Water-Cooled MIG Guns Equipped with Wire Brake, step 3](https://beta.tregaskiss.com/wp-content/uploads/2020/07/quick_load_liner_rwc_3.png)
INS069 REV 08/10