How To Install or Replace TOUGH LOCK Consumables

IMPORTANT:

  • Neck Insulator MUST be in place before welding to properly insulate the neck armor.
  • Check all parts to ensure that connections are tight before welding.
  • The heavy duty retaining head MUST be tightened with a 5/8 inch (16 mm) wrench to prevent the contact tip from overheating.
  • DO NOT use pliers to remove or tighten the retaining head or scoring may result.


TOUGH LOCK® Consumables

How To Install or Replace TOUGH LOCK Consumables

Removal and Replacement

Nozzle

  • Pull slip-on nozzles off with a twisting motion.
  • When installing the nozzle, ensure that it is fully seated.

Contact Tip

  • Thread the contact tip into the retaining head.
  • Torque to 30 in.-lbs. (3.5Nm).
  • The Tregaskiss Tip Tool (part #450-18, for heavy duty tips) or a pair of weld pliers are the optimal tools for contact tip installation.

Retaining Head

  • Thread the retaining head onto the neck with a 5/8 inch (16 mm) wrench.
  • Torque to 80 in.-lbs. (9Nm).
  • DO NOT use pliers to remove or tighten the heavy duty retaining head or scoring may result.

Neck Insulator

  • The neck insulator is pressed onto the neck by hand with the aluminum side towards the neck and the black insulation toward the nozzle.