How to Install the 580-4 Dual Shunt Kit Installation for ThruArm Clutch Connectors
Contact us if you have more complex or technical questions.
Step 1: Removal of Single Shunt
- Remove single shunt using a 4mm Allen key
- Discard OLD shunt and OLD M6x8 SBHCS (2) and washers (2)
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/1ab.jpg)
Step 2: Identification
On the NEW shunts (2), the BLUE dot will indicate the LEFT side shunt (Install on the same side as the Clutch switch)
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/2a.jpg)
The RED dot will indicate the RIGHT side shunt
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/2b.jpg)
NEW M6x10 SBHCS (2) and washers (2)
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/2c.jpg)
Step 3: Installation of New Dual Shunt Kit
- Place right (red dot) over left (blue dot) end of the shunts, then using one M6x10 SCHCS and washer fasten to the brass part (DO NOT tighten completely)
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/3abc.jpg)
2. Using the second M6x10 SBHCS and washer, fasten the other end of the shunts to the clutch body hole marked “DS”
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/3de.jpg)
3. Ensure both M6x10 SBHCS are tightened completely
![](https://beta.tregaskiss.com/wp-content/uploads/2020/12/3fgh.jpg)
Contact us if you have more complex or technical questions.