How To Install or Replace a QUICK LOAD Liner on a TOUGH GUN ThruArm Series Robotic MIG Gun with an LSR Unicable

Remove the rear cap of the power pin.
Insert the brass end of the liner into the liner retainer until it is firmly seated.
Insert the non-brass end of the QUICK LOAD™ Liner into the back of the MIG gun and push through until it emerges from the front of the MIG gun and the liner retainer makes contact with the power pin.

How To Install or Replace a QUICK LOAD Liner on a TOUGH GUN ThruArm Series Robotic MIG Gun with an LSR Unicable, image 2

Thread the QUICK LOAD Liner retainer (#415-26) into the power pin. Torque to 30 in.-lbs. (3.5Nm).
Re-thread the cap of the power pin back on (hand tighten).
Push the liner back into the front of the MIG gun and hold in place.

How To Install or Replace a QUICK LOAD Liner on a TOUGH GUN ThruArm Series Robotic MIG Gun with an LSR Unicable, image 3

Trim the liner to 5/8″ (16 mm) stick out.
Remove any burrs that may obstruct wire feed.

Consumables

Additional Resources

As manufacturers of semi-automatic, fixed automatic and robotic MIG guns and consumables, Tregaskiss and Bernard have earned a reputation as an experienced, dependable partner to its customers in the automotive, construction and fabrication, heavy equipment, ship, rail, general manufacturing, commercial truck and trailer, and oil and gas industries. Tregaskiss and Bernard offer air-cooled semi-automatic, fixed automatic and robotic MIG guns, water-cooled semi-automatic, fixed automatic and robotic MIG guns, reamers, nozzle cleaning stations, anti-spatter liquid, wire cutters, anti-spatter sprayers, clutches, welding consumables, nozzles, MIG welding tips, and MIG welding torches.